Laptop Keyboard Repair and Substitute

Laptop repair san diego.Are you considering laptop keyboard repair? You might suppose twice in the event you happen to be the fortunate owner of a Compaq Presario, as a result of changing the keyboard fairly than repairing it may very well be loads much less expensive. Laptop computer keyboard alternative on this explicit model could be very easy and takes just a few minutes. Here is a fast laptop keyboard repair tutorial with step-by-step instructions.

After you have purchased the brand new keyboard, all it's essential to replace the outdated with the brand new is a screwdriver and something plastic, flat and skinny like a credit card or guitar pick.

The 1st step: Take away the two screws from the bottom of the computer which might be holding down the keyboard bezel. The bezel is the bar that sits proper above all the perform keys.

Step two: Turn the computer over, open the duvet and insert the credit card or guitar decide between the bezel and the computer screen. The bezel has pegs that sit in holes, it's essential to slowly pry up the bezel. It would make a bit of a popping noise as it is removed.

Step three: Now maintain on to the keyboard from the top closest to the display screen and gently pull it away from the contact-pad end and flip it over. You will note the ribbon attached to the underside of the keyboard. There's a little plastic connector holding the ribbon to the computer. To unlock it, carefully pull up on the two tabs; one located on each nook of the connector. Be very gentle if you do this as that is the one part that will get broken probably the most often when changing a keyboard. The ribbon will now be released.

Step 4: Rigorously pull the ribbon out of the connector and take away it together with the whole keyboard.

Remaining step: To insert the brand new keyboard, place the board face down so you might have easy accessibility to the ribbon. Make sure the keyboard is lined up so if you flip it back over the keys are in the correct position. Hold the ribbon straight always; twisting it might harm it. Place the ribbon in the connector; it solely goes in a single way. Once in place, push down on the connector tabs to lock it. Now flip the keyboard over and slide it down toward the contact pad and take the bezel and line the pegs up with the holes and push it in place. Then flip the computer over and replace the two screws you removed from the bottom. Now you can energy in your pc and see if the keyboard works. If it isn't working, greater than seemingly the ribbon was not inserted properly.